You are watching: How to unscrew a ps3 controller
Once the cover is off, the controller have to look choose this. Follow the red and also black wire(s) from the battery to the connector.
Take a pair of tiny pliers and unhook the battery (refer to picture 2 of this action to view it unhooked).
To remove the 4 buttons (2 on each side), very first lift the end the R1 (or L1) button. This might require you come wiggle the button.
For this step, girlfriend will must de-solder the wires that attach the electric motors to motherboard. Or, if girlfriend are prefer me and also don"t have a solder, you deserve to attempt to rip the wires of.
First of, lift the entirety motor the end of the plastic mount. This may take some pressure as that is glued in.
After that, simply cut the cable turn off of the motherboard, or de-solder it. In the an initial picture you have the right to see what her controller will look prefer with one motor missing.
First off, unscrwew the single screw the holds the motherboard onto the plastic (marked the end in orange in the first and second picture ots).
With that screw removed, the totality motherboard (along with the 2 joysticks) can be merely lifted appropriate out.
To eliminate the white plastic, simply lift it out of the controller. There space no screws,clips or glue holding the in.
First of, eliminate the 2 white pieces or rubber ~ above the sides and the middle, grey piece too. The an initial picture shows you what this will certainly look like.
Then just "pop" the buttons out (marked out in orange in picture 2) native the various other side (the front). You can likewise remove the "Play Station" logo design button.
If I have to sacrifice one controller in order come show people how to (potentially) solve theirs, climate I"m completely fine with that.
You can remove the whole motherboard assembly without disconnecting the rumble motors. Simply lift them out at the same time carefully
part wording needs to it is in edited,
(TEAR it DOWN not disassemble. )
Is in reality the very same thing.
Cut wire from board ,
vs rip it off , would certainly work,, lol.
The rubber touch switch pads,,
carbon heap buttons,, just might
be the factor my L2/ R2 quit today,
or dust got under flex circuit strip
that bang contacts the circuit board
seen in current video, scrubbed clean
to make it functional.
Not looking front to the torture,
but not able to shift gears on
Granturismo , or fire motars from
pirate delivery of Assassins Creed Rogue,
is cramping my layout a bit.
Load much more comments
include Comment cancel
Embed this guide
Choose a size and copy the code below to embed this guide as a little widget ~ above your site / forum.
single Step full Guide
tiny - 600px medium - 800px big - 1200px
Past 24 Hours: 16
Past 7 Days: 127
Past 30 Days: 661
All Time: 49,319
Subscribe come our newsletter
discover something new every week:
assist Translate stclairdrake.net
©2021 stclairdrake.net — license is granted under an imaginative Commons — Privacy — state — ease of access